- 1 -
SAFETY INSTRUCTIONS
Please read carefully and follow this user’s guide carefully and completely.
Important: Please keep this user’s guide for reference in order to use the UPS properly and safety.
This user’s guide consists of safety instructions, introduction, front and rear panel,
installation, operation and troubleshooting.
For product safety, please check this product annually by our service qualified personnel or if
there are any symptom of problems which are not mentioned in this guide or any queries, please
contact your LEONICS local distributors, LEONICS Service Center, send e-mail to support@leonics.
com or visit www.leonics.com
For your convenience and quick reference for our service, pleas fill the
requested informations in the blanks below:
UPS
Model:
Serial
Number:
Purchased
Date:
Purchased
From:
Warning
Risk of electric shock, DO NOT remove cover. No user serviceable part inside,
please refer servicing to qualified service personnel.
1.1 Electrical
Safety
1.1.1 Do not work alone where there are electrically hazardous conditions.
1.1.2 Contact with live conductors will cause burns and dangerous electric shock.
1.1.3 Only qualified electricians allow to install and wiring this unit and system.
1.1.4 Periodically check your cable, outlets, terminal blocks and power source to make sure
that they are in good condition.
1.1.5 To reduce risk from electric shock, if you can not find the electrical ground (
) of
the building, connect loads to UPS before plug in the UPS to AC power source.
1.1.6 Do not touch any electrical connection when the unit is operating.
1.1.7 Use ONLY one hand when plugging or unplugging the loads in order to avoid electric
shock from touching two surfaces with different potential.
1.1.8 It is recommended to connect the UPS to a three wires AC power source (two live wires
and an electrical ground) which connects to a protected circuit such as employs a fuse
- 2 -
or circuit breaker.
1.2 Safety instruction for installation and operation
1.2.1 Before installing or using this unit, read all instructions and caution markings on the
UPS and all connected loads, and all sections of this user guide.
1.2.2 Install this unit in a temperature and humidity controlled indoor area with adequate
air flow and away from chemical particles or flammable substances. Avoid installing
the unit near radio transmission station, heat dissipation equipment and direct
sunlight.
1.2.3 This unit has ventilation grills. Ensure that sufficient ventilation is provided. DO NOT
block the ventilation grills. The distance of minimum 30 cm. between the wall and the
unit is necessary.
1.2.4 Use insulated tools to reduce your risk of electric shock.
1.2.5 Remove all jewelry or other metal objects such as rings, necklace, bracelets and
watches when installing this product.
1.2.6 Verify correct terminal block connections to prevent the damage occurs.
1.2.7 Before connecting the communication interface signal cable, turn off the UPS and
disconnect the UPS from utility power source.
1.2.8 Turn on the UPS before turn on all connected loads to prevent surge damage.
1.2.9 DO NOT connect the utility power source into the UPS OUTPUT. This may cause the
UPS
damaged.
1.2.10 During a heavy rain storm, avoid using electrical appliances including the UPS to
prevent damage from lightning strike.
1.2.11 Use soft cloth to clean the UPS when it is turned off. DO NOT clean it with solvent.
1.2.12 This UPS is not intended for use with life rescue equipment! A failure of the UPS might
cause the life rescue equipment to fail and endanger human lives.
1.3 Battery
Safety
1.3.1 The UPS has hazardous voltages inside, do not disassemble any parts of UPS except for
the battery. Users are not allowed to repair, recondition or disassemble the UPS. This
must be done by Leonics qualified technicians only.
1.3.2 The UPS contains sealed lead acid battery and must be recycled properly. For recycling
please return it to a LEONICS local distributor or LEONICS Service Center or contact
your local recycling center for proper disposal information.
1.3.3 Do not dispose of battery in a fire. They may be exploded.
1.3.4 Do not disassemble battery. They contains poisonous electrolyte which is harmful to
your skin and eyes.
1.3.5 Replace battery with the same type and rating.
