FOR ASSISTANCE CALL: 1.888.213.5015 | MON-FRI 8AM-6PM EST
HORIZON SERIES:
HzOTO POWERED SOUNDBAR SETUP GUIDE
5
4
MOUNTING YOUR SPEAKER
Follow the instructions provided with your mounting bracket in order to securely
install the speaker directly to the wall or to your TV. Be sure to allow for ample
ventilation behind amplifier on back of speaker.
CONNECTING YOUR SPEAKER TO THE TV
1. Connect the audio output from the display to the OTO Amp inputs using the
included TOSLINK cable (preferred) or RCA cables.
2. Plug in the AC Power cable to the wall (OTO is self sensing for either 110V
or 220V operation). NOTE: Connecting power will turn on the unit, so be sure
to make all connections prior to providing power.
3. It may be necessary to set the TV audio output to “digital output”and turn off
the internal speakers. Refer to the TV manual for more specific information.
PLAY
1. Follow CONTROL instructions on page 6 to turn on unit and select appropriate
input. NOTE: If using TOSLINK, select “DIGITAL”; for RCA, select “ANALOG”.
2. Power on your TV and make sure you are receiving a signal.
3. Adjust volume and tone as necessary
(see Control, page 6)
OPTIMIZING YOUR SYSTEM
1. Adjust the treble controls to enhance clarity and high frequencies.
2. Adjust the bass controls to tune the low end output to your room.
TIP: The closer the speaker is to the wall, the less bass boost necessary.
3. If using a subwoofer, make adjustments after the subwoofer is placed
and tuned in the room.
CONNECTING LEON’S OTO-RX WIRELESS SUBWOOFER RECEIVER
1. Plug in the wireless receiver using the power cord provided.
2. Connect the audio output of the wireless receiver into the subwoofer
amplifier’s audio input.
3. On the OTO AMP, press and hold the “SYNC” button. Within 30 seconds, press
and hold the “SYNC/CONNECT” button on the back of the wireless receiver.
While syncing, the Leon logo on the front panel will pulsate. If properly synced,
after 30 seconds the Leon logo will remain lit up.
HARDWIRE CONNECTION TO A SUBWOOFER
1. Connect the subwoofer output from the back of the OTO Amp into the audio
input on your subwoofer amplifier.
2. Power on your subwoofer to make sure you are receiving a signal, and make
adjustments as necessary.
CONNECT TO YOUR TV
ADDING A SUBWOOFER
QUICK TIP: NEED TO REBOOT YOUR WIRELESS SYSTEM?
STEP 1: Unplug HzOTO and OTO-Rx wireless subwoofer receiver.
STEP 2: Simultaneously push and hold “SYNC WIRELESS” button located
on OTO rear panel, and “WIRELESS RESET” button located on the bottom
of OTO-Rx receiver.
STEP 3: Plug units back in, and continue to hold until the green LED appears
and flashes on the wireless receiver. Once the green LED begins to blink
every 2 seconds, the SYNC/CONNECT procedure should be followed.
