Acquaer Ltd.
H-490
0, Fehérgyarmat, Szatmári út 11.
Attention to your operating
:
•
Never carry the pump by its cable and do not pull the cable to disconnect it. For
submerging, lifting or securing the pump, fix a rope to the pump^ carrying handle is
the correct choice.
•
Do not pull out the power cable from the socket as a method of turning the pump off.
Check out if the outlet and the inlet of the pump clog. Clear the outlet and the inlet
when need.
Automatic protection for safety:
•
Thermal motor protector: The pump is automatically switched
off on overheating by the built-in thermal motor protector. After
having cooled down, the motor automatically switches on again.
•
Automatic Air bleed valve: The
automatic air bleed valve eliminates any air pockets in the
pump.
During this process, air escapes through the plastic plug on the
pump and air bubbles appear underwater. This is not a defect of
your pump, but serves to deaerate the pump, but serves to remove
air from the pump. It may take several seconds for the air to
escape when the pump is immersed for the first time.
Note:
The position of vent hole may be different in some models.
Main power cables must not have a smaller cross-section than the rubber-sheathed
cables of the designation H05RN-F while the pump without power cable lighter than 5
kg and the designation H07RN-F while the pump without power cable heavier than 5
kg. The cable length must be at least 10m.
Operation
Automatic operation of the float switch
:
The float switch 4 turns the pump on automatically when the water level exceeds the
cut-in height and the water is pumped out. The float switch 4 turns the pump off again
as soon as the water level falls below the cut-out hight.
(1)
Stand the pump on a firm surface or use a rope attached through the bore hole in
the carrying handle 6 to immerse the pump in a well or shaft.
(2)
During automatic operation, ensure that the float switch 4 can move freely.
Plug the power cable 3 into a mains socket.
Adjusting the Cut-in and Cut-out Height: Push the cable of
the float switch 4 into the float switch lock 5.
Do not select a cable length that is too long or short to
ensure that the float switch 4 can turn on and off properly.
The cable length between the float switch 4 and the float
switch lock 5 must always be at least 10 cm.
