Address
Name / setting range / [default setting]
Info
0x2C46
Number of the absolute ascertainable revolutions of
motor encoder
•
Read only
Is set by the firmware according to the available version:
•
0: no absolute value encoder (sin/cos encoder) or resolver with num-
ber of pole pairs > 1
•
1: Single-turn absolute value encoder or resolver with number of pole
pairs = 1
•
>1: Multi-turn absolute value encoder
0x2C47
Open circuit detection sensitivity of motor encoder
1 ... [100] ... 100 %
The sensitivity can be reduced by percentage, e. g. in case of EMC inter-
ferences.
0x608F:001
Position encoder resolution : Encoder increments
•
Setting can only be changed if the inverter is inhibi-
ted.
Setting the number of bits to be used for resolving a mechanical motor
revolution.
Resolving the position detection by the motor encoder.
65536 16 bit
262144 18 bit
1048576 20 bit
4194304 22 bit
16777216 24 bit
67108864 26 bit
268435456 28 bit
1073741824 30 bit
0x608F:002
Position encoder resolution : Motor revolutions
1 ... [1] ... 1
•
Setting can only be changed if the inverter is inhibi-
ted.
Setting of the number of motor revolutions.
Only setting "1" is accepted.
0x6090:001
Velocity encoder resolution : Encoder increments per
second
0 ... [33554432] ... 2147483647
•
Setting can only be changed if the inverter is inhibi-
ted.
Setting of the encoder increments per second.
0x6090:002
Velocity encoder resolution : Motor revolutions per
second
0 ... [125] ... 2147483647
•
Setting can only be changed if the inverter is inhibi-
ted.
Setting of the motor revolutions per second.
12.1.2
Resolver settings
Resolvers with a number of pole pairs > 1 are not absolute value encoders.
Bit 4 in (Lenze status word 2) therefore remains set to "0".
The "distinguishable revolutions" specification in
is also set to "0".
The following applies to synchronous motors:
•
When the number of motor pole pairs to the number of resolver pole pairs is an integer
ratio (
), the pole position only has to be identified once.
•
When the number of motor pole pairs to the number of resolver pole pairs is a non-inte-
ger ratio (
), the pole position must be identified every time the inverter is con-
nected to 24 V.
Synchronous motor: Pole position identification (PPI)
Parameter
Address
Name / setting range / [default setting]
Info
0x2822:025
Axis commands: Get motor encoder characteristic
(resolver)
Values determined in order to compensate for resolver faults.
0 Off/Ready
Obtain Hiperface information from the encoder for application feedback.
1 On/Start
2 In process
3 Action cancelled
4 No access
5 No access (controller inhibit)
Configuring the feedback system
Configure feedback system for motor control
General settings
202
Summary of Contents for i950 Series
