Starting and stopping smoothly and gently
An acceleration ramp and – in contrast to a conventional starter – a deceleration ramp can be
set for Lenze Smart Products. This ensures that the conveyed material is handled in a defined
and jerk-free manner..
Contactor and motor protection functions integrated
The Lenze Smart Products can be started and stopped by mean of digital inputs. It is also
possible to switch between different speeds and rotating directions. Up to 5 different speed
modes (e. g. creep speed and normal speed in both directions as well as stopping) can be used
for a motor. Reversing-contactor changes and pole changes are thus a thing of the past.
In addition, motor-protections devices are not needed as monitoring of temperature, short
circuits, earth faults and phase failures has already been integrated.
Easy installation
Connection takes place completely from the outside by means of connectors.
The Lenze Smart Products come with an especially clever connecting technology – Phoenix
Contact QUICKON. Electrical installation is therefore very easy without special tools and
requires less than one minute.
In addition to the QUICKON connector, the M15 connection customary on the market is
available.
As a standard feature, the digital inputs and outputs are connected at M12 sockets of the type
currently available on the market.
Already existing signal cables can often be reused.
Worldwide and efficient
The drive can be used worldwide:
•
In all 3-phase networks with 400 ... 480 V supply voltage an a mains frequency of
50 ... 60 Hz
•
At ambient temperatures of -30 ... +40 °C
•
Is suitable for many approvals
The Lenze Smart Motor fulfils the requirements as described in the highest efficiency
requirement for IES2.
If very little torque is needed in the partial-load operational range, the integrated energy
saving function can be used to optimize the energy absorption of the drive.
Product information
Product description
9
