ENGLISH
4
Safety information
Operation
Systems including controllers must be equipped with additional monitoring and protection devices
according to the corresponding standards (e.g. technical equipment, regulations for prevention
of accidents, etc.). You are allowed to adapt the controller to your application as described in the
documentation.
DANGER!
•
After the controller has been disconnected from the supply voltage, live components
and power connection must not be touched immediately, since capacitors could be
charged. Please observe the corresponding notes on the controller.
•
Do not continuously cycle input power to the controller more than once every 3 minutes.
•
Please close all protective covers and doors during operation.
Note for UL approved system with integrated controllers
UL warnings are notes which apply to UL systems. The documentation contains special information
about UL.
Warnings!
• Suitable for use on a circuit capable of delivering not more than 5000 rms
symmetrical amperes, 240 V maximum (240 V devices) or 500 V maximum
(400/500 V devices) respectively
• Use minimum 75 °C copper wire only.
•
Shall be installed in a pollution degree 2 macro-environment.
1.1
Pictographs used in these instructions
Pictograph
Signal word
Meaning
Consequences if ignored
DANGER!
Warning of Hazardous
Electrical Voltage.
Reference to an imminent danger that may
result in death or serious personal injury if
the corresponding measures are not taken.
WARNING!
Impending or possible
danger for persons
Death or injury
STOP!
Possible damage to
equipment
Damage to drive system or its surroundings
Note
Useful tip: If observed,
it will make using the
drive easier
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
