Lenze E70AC Series, Hardware Manual

Page: 125 / 162

Commissioning
Before switching on
8
l
125
EDS700ACBA EN 5.1
8 Commissioning
)
Note!
ƒ
Please observe the general safety instructions (
¶
13).
ƒ
Please observe the notes regarding residual hazards (
¶
18).
8.1 Before switching on
Prevent injury to persons and damage to property by checking the following before
switching on the mains voltage.
Check
ƒ
the wiring for completeness.
ƒ
for the absence of short circuits and/or earth faults.
ƒ
for the correct covering of the DC−bus wiring.
ƒ
the "EMERGENCY OFF" function of the entire system.
ƒ
the motor circuit configuration (star/delta). It must be adapted to the output
voltage of the controller.
ƒ
the in−phase connection of the motor (direction of rotation).
ƒ
whether the drive mechanically can be disconnected from the machine for
commissioning.
}
Danger!
High hazard potential during commissioning
Incorrect settings can cause unexpected and dangerous movements of the
motor and the equipment.
Possible consequences:
ƒ
Damage to material assets
ƒ
Injury to persons
Protective measures:
ƒ
Clear hazard area
ƒ
Observe safety instructions and safety distances
8.2 Quick commissioning
Quick commissioning is described in
ƒ
the "Controller−based automation, EtherCAT" communication manual,
– the chapter "Commissioning of i700 servo inverter".