4
Module
EDBC250SBC |1.1
l
l
l
l
20
4.1.2
Status LEDs
The LED labeled "EtherCAT Run" indicates the state of the EtherCAT ASIC
State
LED flash code
Explanation
Init
Off
Initialisierung,
no data exchange
Pre-Op
Off /green, 1:1
Pre Operational,
no data exchange
Safe-Op
Off /green, 5:1
Safe Operational,
inputs readable
Op
Green, On
Operational,
unrestricted data exchange
LED "In L/A", LED "Out L/A"
Die LED "In L/A" und "Out L/A" zeigt den physikalischen Zustand des jeweiligen Ethernet-Ports
an (Link/Activity).
State
LED flash code
Explanation
Not connected
Off
No Ethernet connection
Connected
Green, on
Connected to Ethernet
Traffic
Green, flashing
Exchanging Telegrams
4.1.3
Function
see page 19
Module state
Variable
Data type Explanation
Undervoltage BOOL
Low voltage (supplied power < 19,2V)
Technical data
General device date
Function
Connects a 100 Base-TX EtherCAT with the Lenze Safety modules.
Generates the LVDS system voltages.
Controller
ASIC ET1100
Baud rate
100 Mbit/s
Cable
CAT5
Length of cable
max. 100m between 2 Safety bus couplers
Ports
2 x RJ45
Power supply
24 V DC -20 % +20 %
Connector Power
Plug 2-pole (part of the module)
Input current
50 mA + E-Bus-Supply
E-Bus power supply
max. 3 A (approx.. 20 Module)
E-Bus load
195 mA
Part no
13520258
Approvals
EtherCAT telegram size
Input
1 Byte
Output
0 Byte
FSoE Input
0 Byte
FSoE Output
0 Byte
