7
1. Plug cord from charger into charger base.
(IMPORTANT: Do not use any other
charger,
only use the product comes with a charger)
2. Plug the charger into electrical outlet. (IMPORTANT: Do not charge by means of an
engine generator or DC power source. Use only 230V AC.
3. Slide the charger onto the battery pack .The power LED and charge LED will light up,
Allow the battery to fully charge before use. After the initial charge and under normal
usage, your battery pack should be fully charged in 5 to 7 hours.
4. Unplug charger. Remove the charger by sliding off
5. Place the battery pack in the tool and be certain that it is inserted fully into the tool cavity until
it “clicks” into place.
(
See Fig.1)
IMPORTANT CHARGING NOTES
Your battery pack was sent from the factory in an uncharged condition.
1. After normal usage, your battery pack should be fully charged in 5 to 7 hours. If the
battery pack is run-down completely, it may take up to 7 hours to become fully charged.
Allow the battery to cool down 30 minutes before charging after using the saw.
(NOTE: A hot battery placed in the charger will not charge and reduce battery life)
2.
DO NOT
charge the battery pack in an air temperature below 40°F (4.5 °C) or above
105°F (40.5 °C). This is important and will prevent serious damage to the battery pack.
Longest life and best performance can be obtained if battery pack is charged when air
temperature is about 75°F (24°C).
3. While charging, the charger may hum and become warm to touch. This is a normal
condition and does not indicate a problem.
4. If the battery pack does not charge properly
• Check current at receptacle by plugging in a lamp or other appliance.
• Try another receptacle
• Move charger and battery pack to a surrounding air temperature of 4.5°C (40°F) to
40.5°C(105 °F)
• If the receptacle and temperature are OK, and you do not get proper charging contact
Lenoxx Electronics on 1300 666 848
5.
The battery pack should be recharged when it fails to produce sufficient power on jobs
which were easily done previously. DO NOT CONTINUE using product with its battery
pack in a depleted condition.
6. To prolong battery life, avoid leaving the battery pack on charger for extended periods
of time (over 30 days without use). Although overcharging is not a safety concern, it can
significantly reduce overall battery life.
7. The battery pack will reach optimum performance after being cycled 5 times during
normal usage. There is no need to run the batteries down completely before recharging.
Normal usage is the best method of discharging and recharging the batteries.