Lenovo V130-20IGM AIO, User Manual And Hardware Maintenance Manual

Page: 38 / 60

Figure 47. Installing the M.2 storage drive screw
8. Reinstall the removed parts. To complete the replacement, see “Completing the parts replacement” on
page 49.
Replacing the memory module
Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide .
If your computer supports one memory module, install the module into the DIMM 1 slot. If your computer
supports two memory modules, install one memory module into the DIMM 1 slot first and then install the
other into the DIMM 2 slot.
1. Remove any media from the drives and turn off all connected devices and the computer. Disconnect all
power cords from electrical outlets and disconnect all cables from the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the computer cover is against the surface and the screen is facing up.
3. Remove the tilt-only monitor stand base. See “Replacing the tilt-only monitor stand base” on page 17.
4. Remove the front cover. See “Removing the front cover” on page 17.
5. Remove the tilt-only monitor stand. See “Replacing the tilt-only monitor stand” on page 19.
6. Remove the system board shield. See “Replacing the system board shield” on page 27.
7. Replace the memory module.
Figure 48. Removing the memory module
34
V130–20IGM AIO User Guide and Hardware Maintenance Manual