9
Safety Information
IMPORTANT: Each caution and danger statement in this document is labeled with a number. This number is used to cross reference an English-language caution or
danger statement with translated versions of the caution or danger statement in the Safety Information document.For example, if a caution statement is labeled
“StatementInformationdocumentunder1”, tra “Statement 1.”
Be sure to read all caution and danger statements in this document before you perform the procedures.Be sure to read all additional safety information
that comes with the server and the optional device before you install, remove or replace any device.
Statement 1
DANGER
Electrical current from power, telephone, and communication cables is hazardous. To avoid a shock hazard:
•Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this Product during an electrical storm.
•Connect all power cords to properly wired and grounded electrical outlets.
•Connect all equipment that will be attached to this Product to properly wired outlets.
•When possible, use one hand only to connect or disconnect signal cables.
•Never turn on any equipment when there is evidence of fire, water, or structural damage.
•Disconnect the attached power cords, telecommunications systems, networks, and modems before you open the device covers, unless otherwise
instructed in the installation and configuration procedures.
•Connect and disconnect cables as described in the following table when installing, moving, or opening covers on this Product or the attached devices.
The power button on the front panel does not disconnect the internal system from the AC power supply completely. To prevent electrical shock
and equipment damage, be sure to unplug the power cord from the power outlet before performing any operation described in this manual.
To connect:
To disconnect:
1. Turn everything OFF.
1. Turn everything OFF.
2. First, attach all cables to devices.
2.
First, remove power cords from outlet.
3. Attach signal cables to connectors.
3.
Remove signal cables from connectors.
4. Attach power cords to outlet.
4.
Remove all cables from devices.
5. Turn device ON.
Do not plug or unplug any connector from the chassis backplane without first disconnecting the power supply.
Statement 2
DANGER
Danger of explosion if battery is incorrectly replaced. When replacing the lithium coin cell battery, use only the same or an
equivalent type that is recommended by the manufacturer. The battery contains lithium and can explode if not properly
used, handled, or disposed of.
Do not:
1.
Throw or immerse into water
2.
Heat to more than 100
℃
(212
℉
)
3.
Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Statement 3
