29
5.
Turn off all attached devices and the server.
6.
Disconnect the AC power cord from the electrical outlet.
7.
Remove the server cover. (See "Removing and reinstalling the server cover")
8.
Use screw drive to release the OCP card bracket screw (Step1) and remove the bracket (Step2).
9.
Remove OCP shroud (Step3).
10.
Bend the four clips that lock the OCP card to the system board, then lift the OCP card off the system board.
Removing a OCP card
To reinstall, reverse the steps above.
2.2.13 INSTALLING OR REPLACING THE DUMMY TRAY FOR A HOT-SWAP DRIVE
Do not proceed before reading and understanding the "Safety Precautions" section of this chapter and "Read Me First".
Note: The diagrams below are relevant for servers with 3.5-inch hard drive configuration only.
To remove the dummy tray for a 3.5-inch hot-swap drive, do the following:
1.
Grab the handle of the dummy tray
2.
Pull the HDD dummy tray out of the chassis.
Grab the handle of the HDD dummy tray