© Copyright Lenovo 2020
ThinkSystem 440-16i SAS/SATA PCIe Gen4 12Gb Internal HBA Installation and User
Guide
3
1.5
Adapter Characteristics
The adapter is a 6.02 in. × 2.67 in. (153 mm × 67.7 mm) board. The following figure shows the connectors and LED
locations on the adapter.
Figure 1
Card Layout for the Thinksystem 440-16i SAS/SATA PCIe Gen4 12Gb Internal HBA
The following table describes the headers and connectors on the adapter.
Table 2
Headers and Connectors
Connector
Type
Description
J2
Standard edge card connector
The interface between the storage adapter and the host system.
J4
Default serial boot ROM (SBR)
2-pin connector. Reserved.
J8
On-board serial UART connector 4-pin connector. Reserved.
J5 (C3), J6 (C2),
J17(C1), J18
(C0)
Storage interface connectors
Four SFF-8654 4-port internal connectors.
Connect the adapter by cable to the storage devices.
J25
Power
Power connector.
The following table describes the LEDs on the adapter.
Table 3
LED Designations
LED Type
Description
LED 2 Yellow controller over temperature Stays on solid to indicate that the SAS3816 device temperature sensor is over the
temperature threshold. When the device is in the proper temperature range, this LED is off.
LED 3 Green system heartbeat
Indicates that the SAS3816 IoC ASIC is operating normally. This LED blinks at 1 Hz.
J17 (C1)
J18 (C0)
J8
J4
LED3
LED2
J5 (C3)
J6 (C2)
J2
J25
