Lenovo ThinkServer TS150, User Manual And Hardware Maintenance Manual

Page: 93 / 148

5. Position the front USB assembly onto the chassis and slide it to the left as shown. Then, install the
screw to secure the front USB assembly in place.
Figure 68. Installing the front USB assembly
6. Connect the front USB assembly cable to the front USB 3.0 connector on the system board. See
“Server components” on page 17.
Thermal sensor
• “Removing the thermal sensor” on page 79
• “Installing the thermal sensor” on page 80
Removing the thermal sensor
To remove the thermal sensor, do the following:
1. Prepare your server. See “Preparing your server and removing the server cover” on page 41.
2. Remove the front bezel. See “Removing the front bezel” on page 42.
3. Locate the thermal sensor. See “Server components” on page 17.
4. Disconnect the thermal sensor cable.
Chapter 5
.
Replacing hardware
79