Figure 6. Front view of the ThinkServer n400 enclosure
The sd350 also supports a SATADOM flash drive, which is installed in SATA port 1 on the system board.
See the photo of the internals of the sd350 in the
Locations of key components and connectors
section for
the location of the port.
The following figure shows where the SATADOM drive is installed.
Figure 7. SATADOM flash drive installation.
SATADOM options are listed in the
Internal drive options
section.
For configurations where not all drive bays are filled with drives, sufficient fillers should be installed to fill all
empty drive bays to ensure proper cooling. From the factory, either single-bay or four-bay fillers are used.
For example, if no drives are configured, then one four-bay and two single-bay fillers are used.
As you add a drive, you remove the filler bay and replace it with a drive. A special case is if only two drives
are installed in the factory. In such a configuration, the remaining four bays have a single four-bay filler
inserted. If you wish to add a third drive, you will need to remove the four-bay filler and install the drive.
The remaining three bays must be installed with three single-bay fillers which will need to be ordered
separately. Ordering information for the single-drive filler is in the following table.
Table 9. Single-bay filler for drive bays
Part number
Feature code
Description
00YK797
A4C2
HDD Filler ASM GEN 3 Single Filler
Lenovo ThinkServer sd350
14
