Lenovo ThinkAgile MX3321-F, User Manual

Page: 72 / 126

Step 1. Slide the left-side latch to the unlocked position.
Step 2. Push and hold the right-side latch in the direction as shown.
Step 3. Grasp the RAID adapter by its edges and carefully remove it from the RAID adapter slot on the
system board.
If you are instructed to return the old RAID adapter, follow all packaging instructions and use any packaging
materials that are provided.
Install the RAID adapter
Use this information to install the RAID adapter on the system board.
Chapter 4 “ Read
the
installation
Guidelines” on
page 29
“ Power off
the server
for this task”
on page 34
“ ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 31
Note: The following procedure applies to RAID adapter installed on the system board. For the procedure
about installing the RAID adapter installed on the riser assembly, refer to “Install a PCIe adapter” on page 61.
Before installing the RAID adapter:
1. Touch the static-protective package that contains the new RAID adapter to any unpainted surface on
the outside of the server. Then, take the new RAID adapter out of the package and place it on a static-
protective surface.
2. If the new RAID adapter is installed with a bracket, remove the bracket.
To install the RAID adapter on the system board, complete the following steps:
Figure 45. RAID adapter installation
Step 1. Place the RAID adapter into the slot at an angle.
Step 2. Rotate the RAID adapter down.
Step 3. Push the right-side latch open.
Step 4. Push the RAID adapter to the fully horizontal position and insert it into the RAID adapter slot.
Step 5. Slide the left-side latch to the locked position.
After installing the RAID adapter on the system board:
1. Connect cables to the new RAID adapter. See “Internal cable routing” on page 33.
2. Complete the parts replacement. See “Complete the parts replacement” on page 34.
68
ThinkAgile MX Certified Node 1UThinkAgile MX3321-H, MX3321-FUser Guide