Lenovo System x3650 M4 HD, Installation And Service Manual

Page: 281 / 1168

Replacing the system battery
The following notes describe information that you must consider when replace the system battery in the
server.
• When replacing the system battery, you must replace it with a lithium battery of the same type from
the same manufacturer.
• To order replacement batteries, call 1-800-426-7378 within the United States, and 1-800-465-7999 or
1-800-465-6666 within Canada. Outside the U.S. and Canada, call your Lenovo sales representative or
Lenovo reseller.
• After you replace the system-board battery, you must reconfigure the server and reset the system date
and time.
• To avoid possible danger, read and follow the following safety statement.
Statement 2
CAUTION:
When replacing the lithium battery, use only Lenovo Part Number 33F8354 or an equivalent type
battery recommended by the manufacturer. If your system has a module containing a lithium battery,
replace it only with the same module type made by the same manufacturer. The battery contains
lithium and can explode if not properly used, handled, or disposed of.
Do not:
• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the replacement system battery, complete the following steps:
Step 1. Follow any special handling and installation instructions that come with the replacement battery.
Step 2. Read the safety information that begins on “Safety” on page v and “Installation guidelines”
on page 34.
Step 3. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 4. Remove the cover (see “Removing the cover” on page 195).
Step 5. If necessary, lift the PCI riser-card assembly 2 out of the way (see “Removing a PCI riser-card
assembly” on page 221).
Step 6. Insert the new battery:
Chapter 6
.
Removing and replacing components
269