Step 1. Remove the top cover. See “Remove the top cover” on page 106.
Step 2. Remove the air baffle. See “Remove the air baffle” on page 29.
Step 3. Remove any parts and disconnect any cables that might impede your access to the heat sink and
processor.
Step 4. Remove the heat sink.
Figure 47. Heat sink removal
a. Use a Torx #T20 screwdriver to loosen all the captive screws in the
removal sequence
shown
on the heat-sink label. After loosening each captive screw, wait for several seconds for the
heat sink to loosen from the processor.
b. Slightly lift the heat sink away from the system.
After you finish
• If you are replacing a heat sink, install a new heat sink. See “Install a T-shaped heat sink” on page 79.
• If you are replacing a processor, remove the processor. See “Remove a processor” on page 75.
Remove a processor
Use this information to remove a processor.
About this task
Attention:
.
Hardware replacement procedures
75
Summary of Contents for HR630X V2
