Lenovo HR630X V2, User Manual

Page: 50 / 134

1. Reinstall all the drives and drive fillers into the drive bays. See “Install a hot-swap drive” on page 38.
2. Complete the parts replacement. See “Complete the parts replacement” on page 110.
Remove the front 3.5-inch-drive backplane
Use this information to remove the front 3.5-inch-drive backplane.
About this task
Attention:
• Read “Installation Guidelines” on page 27 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Note: Depending on the specific type, your backplane might look different from the illustration in this topic.
Step 1. Prepare your server.
a. Remove the top cover. See “Remove the top cover” on page 106.
b. Remove the system fan cage for easier operation. See “Remove a system fan” on page 97.
c. Remove all the installed drives and fillers (if any) from the drive bays. See “Remove a hot-swap
drive” on page 37.
42
HR630X V2 User Guide