Lenovo E50-80, Hardware Maintenance Manual, Page: 85 / 92

Removal steps of the camera and LCD cable
Disconnect the connector 1 , remove the integrated camera from the LCD cover in the direction shown by
arrow 2 , and then release the LCD cable from the cable guide 3 .
b
c
a
When installing: Stick the integrated camera to the top center of the LCD cover and adjust the placement of
it to make sure the connector is attached firmly.
Attention: As you route the cables, ensure that they are not subject to any tension. Tension could cause the
cables to be damaged by the cable guides, or a wire to be broken.
1170 Antenna assembly and LCD cover
For access, remove these FRUs in order:
•
“1010 External battery pack” on page 52
• “1020 Keyboard” on page 52
• “1030 Optical disk drive” on page 54
• “1040 Base cover assembly” on page 56
• “1050 Hard disk drive or solid-state hybrid drive” on page 58
• “1060 Wireless-LAN /Bluetooth card” on page 59
• “1080 Upper case” on page 61
• “1090 Audio board, audio board cable, power board, touch pad board cable, finger printer board,
LED board and ODD switch board” on page 63
• “1100 System board” on page 66
• “1120 Speaker assembly, docking LED lens and docking bracket” on page 72
• “1130 LCD unit, docking board, docking cable and DC-in cable” on page 73
• “1140 LCD front bezel” on page 76
• “1150 LCD panel, EDP cable and hinges” on page 76
• “1160 Integrated camera and LCD cable” on page 78
Removal steps of the antenna assembly and LCD cover
Peel off the adhesive tapes securing the antenna boards, release the cables from the cable guide, and then
remove the antenna assembly in the direction shown by arrow
1 .
a
a
Chapter 10
.
Removing or replacing a FRU
79