Lenovo 8013, Hardware Maintenance Manual, Page: 166 / 582

Important
Refer to “Safety notices (multi-lingual translations)” on page 7 for information
about replacing and disposing of the battery.
1. Remove the computer cover. See “Removing the cover” on page 129.
2.
Locate the battery. See the system board illustration for your machine type at
“Identifying parts on the system board” on page 130.
3. You might have to remove any PCI adapters that impede access to the battery.
4. Remove the old battery.
5. Install the new battery.
6. Replace any PCI adapters that were removed.
Note: When the computer is turned on for the first time after battery
replacement, an error message might be displayed. This is normal after
replacing the battery.
7. Go to “Completing the FRU replacement.”
Completing the FRU replacement
After replacing FRUs, you need to install any removed parts, replace the cover, and
reconnect any cables, including telephone lines and power cords. Also, depending
on the FRU that is replaced, you might need to confirm the updated information in
the Setup Utility program.
Note: When the power cord is first plugged in, the computer might appear to turn
on for a few seconds and then turn off. This is a normal sequence to enable
the computer to initialize.
1.
Ensure that all components have been reassembled correctly and that no tools
or loose screws are left inside your computer.
2. Replace the cover.
3.
Reconnect the external cables and power cords to the computer. See “Rear
connectors” on page 128.
4. If you have replaced the system board, you must update (flash) the BIOS. See
“Flash update procedures” on page 570.
5. Some FRU replacements require the configuration to be updated. See Chapter 6,
“Using the Setup Utility,” on page 51.
160
Hardware Maintenance Manual