Lenovo 8013, Hardware Maintenance Manual, Page: 119 / 582

5. Use the blue handle to pivot the hard disk drive and bracket upward, slide
the hard drive to the left until it is free of the retaining clips in the bottom of
the chassis, and then completely remove it from the chassis.
6. Remove the blue bracket from the failing hard disk drive by flexing the
bracket.
7. Install the new drive into the blue bracket, flex the bracket, and align the pins
1
through
4
on the bracket with the holes in the hard disk drive. Do not
touch the circuit board
5
on the bottom of the hard disk drive.
8.
Position the hard disk drive and bracket so that it engages the retaining clips
in the bottom of the chassis when you slide the bracket to the right.
9. Slide the hard disk drive and bracket to the right until it snaps into position.
10. Connect the signal and power cables to the rear of the hard disk drive.
Chapter 8. Replacing FRUs (desktop computers)
113