Lenovo 7359 - ThinkCentre M58 - 2 GB RAM, Hardware Maintenance Manual

Page: 83 / 348

Figure 13. Removing the front audio and USB assembly
5. Remove the failing front audio and USB assembly from the chassis.
6. Install the new front audio and USB assembly into the chassis and secure it with the screw.
7. Connect the front audio and USB assembly cables to the system board.
8. To reinstall the front bezel, align the plastic tabs on the bottom of the bezel with the corresponding holes
in the chassis, then pivot the bezel inward until it snaps into position.
9. Go to “Completing the FRU replacement” on page 89.
Replacing the heat sink
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the
ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide , go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the heat sink.
CAUTION:
The heat sink might be very hot. Turn off the computer and wait three to five minutes to
let the computer cool before opening the computer cover.
To replace the heat sink:
1. Open the computer cover. See “Opening the computer cover” on page 71.
2. Locate the heat sink. See “Locating components” on page 69.
3. Remove the four screws that secure the heat sink to the system board.
Note: Carefully remove the four screws from the system board to avoid any possible damage. The four
screws cannot be removed from the heat sink.
Chapter 8
.
Replacing FRUs
77