1-4
L195 Wide Flat Panel Monitor User’s Guide
Connect the digital cable to the DVI connector of the monitor and the other end
on the back of the computer.
Note: The digital cable is not included with the monitor.
Insert the power cord into the monitor ,then plug the monitor power cord and the
computer cord into grounded electrical outlets.
Place the cable into the specific hook indicated in below figure.
4.
5.
Place the cable into the specific hook indicated in below figure.
Note
: A certified power supply cord has to be used with this equipment. The relevant
national installation and/or equipment regulations shall be considered. A certified
power supply cord not lighter than ordinary polyvinyl chloride flexible cord
according to IEC 60227 (designation H05VV-F 3G 0.75mm
2
or H05VVH2-F2 3G
0.75mm
2
) shall be used. Alternative a flexible cord be of synthetic rubber
according to IEC 60245 (designation H05RR-F 3G 0.75mm
2
) shall be used.
6. Replace the Cable Cover.
