
CLEANING AND MAINTENANCE
1.
Disconnect the appliance from the mains , before cleaning.
2.
Do not use solvents or abrasive products to clean the iron, clean with a damp cloth.
TROUBLESHOOTING
Do not to replace a defective power cable . The unit must be returned to an authorized
service center for repair.
Iron emits smell or smoke
The iron gives off a smell when it is switched on for the first time. And ' necessary to allow
the lubricant used in the manufacture of burn . After a few minutes the smell will disappear
Iron does not heat
The iron must be plugged into an electrical outlet conform to its specifications . If the outlet
checked .
The thermostat must be set to the desired temperature .
Iron does not emit steam
The water tank may be empty. Turn the steam selctor to "0" and add water.
Check that the thermostat is set correctly at the desired temperature .
After pressing the button of the burst of steam ,the iron does not produce any
steam
The water tank must be filled for at least 1/4 of its capacity. The temperature must be set
in position steam. The iron must be in a horizontal position . Allow a short pause between
shots. Be sure to press the shutter button completely blow of steam.
After pressing the button of the spray, the iron does not expel the water
The water tank must be filled for at least 1/4 of its capacity. Fill the iron as described in the
section "How to fill the water tank