17
r
emoVIng
and
I
nstallIng
UVa l
amP
, l
amPholder
and
a
Ir
f
Ilter
IMPORTANT
If the system has been operated for a period of time
without the UVA lamp being illuminated, an odor may
occur when lamp is illuminated. This odor is considered
typical and should dissipate within 12 hours of full
operation. If the odor does not subside after 48 hours
of operation, instruct the homeowner to unplug the unit
and contact a Lennox dealer.
CAUTION
Personal Burn Hazard.
UVA lamp is very hot when illuminated.
Allow lamp to cool for 10 minutes before removing lamp
from socket.
Injury may result from contact with hot UVA lamp.
1. Remove power cord from 120VAC or 230VAC
receptacle.
2.
Remove power cord from unit.
3. Remove access panel.
4. Remove Healthy Climate
®
Carbon Clean 16
®
Filter.
5. Rotate out the hinged control panel.
6.
Disconnect UVA lamp electrical connector from ballast.
7.
Remove both fasteners securing the UVA Lampholder /
PCO cartridge from the chassis.
8. Slide out the UVA Lampholder / PCO cartridge from the
chassis.
9.
Remove both brass finger nuts that secure the UVA
lamp elector connector to the UVA Lampholder / PCO
cartridge.
10. Slide out UVA lamp from UVA Lampholder / PCO
cartridge insert.
11.
Push the red button on UVA lamp electrical connector
and gently slide off connector from UVA lamp (do not
dispose of UVA lamp electrical connector).
12. Properly dispose of UVA lamp and air filter.
13. Reinstall in reverse order starting.
P
roPer
c
lean
-U
P
of
b
roken
UVa l
amP
If UVA lamp is broken, it must be disposed of properly.
• Wear protective gloves, eye wear and mask.
• Sweep broken glass and debris into a plastic bag and
seal before disposal in accordance with instructions
provided by local waste management office.
• Do not use a vacuum cleaner. Do not incinerate.
