Page 36
Burner starts and fires, but locks out on safety.
Source
Procedure
Causes
Correction
Unbalanced fire
Replace nozzle
If burner con
ti
t
Too much air − −lean short fire
Reduce combustion air − check
combustion.
Poor Fire
tinues to run,
this may be
due to poor
Too little air − − long dirty fire
Increase combustion air − check
combustion.
due to poor
fire. Inspect
fire.
Excessive draft
Adjust barometric damper for
correct draft.
After burner
fires, immedi
ately jumper
Too little draft or restriction
Correct draft or remove restric
tion.
ately jumper
across flame
If fire is good,
Dirty cad cell face
Clean cad cell face.
Flame Detector
across flame
detector termi
nals at the pri
mary control
If fire is good,
fault is in the
flame detector.
Ch
k d t
Faulty cad cell − exceeds 1500
hms
Replace cad cell.
mary control.
Check detec
tor circuit.
Loose or defective cad cell
wires
Secure connections or replace
cad cell holder and wire leads.
Primary Control
If burner locks
out on safety,
fault is in the
primary con
trol.
Primary control circuit defective
Replace primary control.
Burner starts and fires, but loses flame and locks out on safety.
Source
Procedure
Causes
Correction
Unbalanced fire
Replace nozzle
If burner con
tinues to run
(d
t l
k
Too much air − − lean short fire
Reduce combustion air − check
combustion.
Poor Fire
(does not lock
out of safety),
fault may be
Too little air − − long dirty fire
Increase combustion air − check
combustion.
fault may be
due to poor
fire. Inspect
fi
Excessive draft
Adjust barometric damper for
correct draft.
After burner
p
fire.
Too little draft or restriction
Correct draft or remove restric
tion.
After burner
fires, immedi
ately jumper
If fire is good,
Dirty CAD cell face
Clean CAD cell face.
Flame Detector
ately jumper
across flame
detector termi
If fire is good,
fault is in the
flame detector.
Ch
k d t
Faulty CAD cell − − exceeds
15000 hms
Replace CAD cell.
Flame Detector
detector termi
nals at the pri
mary control.
Check detec
tor circuit.
Loose or defective cad cell
wires
Secure connections or replace
cad cell holder and wire leads.
Pump loses prime − air slug
Prime pump at bleed port
If burner loses
flame (does
not lock out on
Pump loses prime − air leak in
supply line
Check supply line for loose con
nections and tighten fittings.
not lock out on
safety), fault is
in the fuel sys
Water slug in line
Check oil tank for water (over 1
inch) pump or drain out water.
Oil Supply
in the fuel sys
tem.
Partially plugged nozzle or
nozzle strainer
Replace nozzle.
Restriction in oil line
Clear restriction.
Listen for pump whine
Plugged fuel pump strainer
Clean strainer or replace pump.
p
p
Cold oil − outdoor tank
Change to number 1 oil.
