7-Day Programmable
iComfort Wi‐Fi
®
Flex Thermostat
13
NOTE - Time from pushing the registration button on the
thermostat and receiving the consumer portal register
link from your email on your computer is normally from 5
to 15 minutes depending on Internet speed and traffic.
6.
After registration has been completed, press the
connection status icon to verify the connection was
successful. If the connection is successful the server
icon background will be green.
7.
After successful connection to the server is
completed, the
firmware update
button will appear.
The default setting is set to auto. If any firmware
updates are available they will immediately start
downloading and update the thermostat. The
thermostat will reboot itself after the update is
completed. Updates are done in the background and
will not impair normal thermostat operations.
This auto update feature can be disabled by
pressing the firmware update button to toggle to
OFF but is not recommended.
NOTE - Firmware updates will not affect installer or user
thermostat settings. Both will be retained after the
update.
WI-FI SETTINGS
connected
Wi-Fi
enabled
thermostat
registered
Connection to server has not bee established or it has been lost.
Please wait until a connection is established.
firmware
update
auto
press to enable /
disable Wi-Fi
press to change
wireless network
press to change
thermostat
registration
press to search
for new update
NOTE
-
If any downloads are available for the thermostat they will start down
loading right away. When new firmware is being downloaded or when
Gelaskins are being installed, the thermostat screen will temporarily go
blank and running units may cease operation while the system is being
reset to accommodate the new changes. This is normal and can last
a couple minutes.
AP3
connection
status
press to see
connection status
Figure 12. Registration for Online Access
