Lenel DirecDoor, Installation Manual

Page: 66 / 90

Controller Firmware Tools
66
DirecDoor Installation Guide
4.
When the Integrated Configuration Tool starts, enter your username and password. The default is
install, install
. We recommend that you change this default.
If you need to flash the controller, refer to Upgrading the Controller Firmware on page 72 .
Controller Setup Overview
To set up the controller, complete the following forms:
•
Controller Information Menu > Parameters Form : Set the host port number.
•
Controller Parameters Menu > Primary Network Form : Set up static or dynamic IP addressing.
•
Controller Parameters Menu > Secondary Network Form : This form is available if the controller
has a secondary Network Interface Card (NIC). Set up static or dynamic IP addressing.
Notes:
The ICT screens included in this section are examples only. The actual fields visible on
each form vary depending upon which configuration options you have selected.
The DDSDC does not support the Secondary Network Form.
Saving Configuration Changes
Before using the ICT, note the following details about saving your changes:
•
If you change any options on a form, you must click the Save button at the bottom of the form to
save your changes before switching to another form. This action saves your latest changes to a
temporary file.
•
After completing all the forms, click Reset Controller for the changes to take effect. Changes
will be saved to the controller’s
config
file.
Controller Information Menu > Parameters Form
Access the Controller Information menu and use the Parameters form to set the host Port Number.
Once the controller is configured, this form shows the controller’s serial number, the controller type,
the online/offline status, and the firmware build version.
ICT Buttons and When to Use Them
Button Usage Result
Save After making changes
on any form
Saves the changes to the controller.
Reset
Controller
After selecting Save The operating system picks up the latest changes and
starts again.
Factory
Defaults
a
a. If the default parameters are restored using the SW7 switch (refer to Switches and Jumpers on page 29 ),
then all parameters (including the IP of the controller) get modified.
To restore the
controller’s default
settings The controller’s settings are restored to factory defaults.
The IP address settings of the controller are retained.
Change
User/
Password To set the username
and/or password used
to log on to the ICT. Changes the username and/or password for the ICT.
By default, these values are
install, install
.
For increased security, we recommend that you change
the default values.