Lencore GOLD A1U, Design, Installation And Operation Manuallines, Page: 16 / 43

1. Cut a 4.5” hole in the drywall or acoustical ceiling tile
2. Install the Cat 5e cable with standard RJ45 connector into the speaker
3. While lifting both torsion springs into a vertical position, slide the speaker into the hole until
the grill is flush with the drywall or acoustical ceiling tile; the torsion springs should hold the
speaker firmly in place
1.
For first speaker connection to OP: Connect the audio cable– 8 conductor CAT5 from OP
channel (either A, B, C, or D) to INPUT of speaker.
2.
For speaker to speaker connection: Connect audio cable– 8 conductor from OUTPUT of
previous speaker to INPUT of next. Follow the same series connections to add up to 8
speakers per channel. The last speaker in any channel will have only one cable going to
its INPUT only. There will be no cable connected to the output.
Note: If a *tile bridge is being installed: After hole is cut in the tile, lay tile bridge across the
suspension grid. Push the torsion springs back on speaker and put speaker through both ceiling
tile and tile bridge before releasing springs to hold speaker in place in tile bridge.
*A load-bearing T-bar support designed to sustain the weight of a direct fired Tangent speaker in
suspended ceiling construction. Use of the Tile Bridge improves environmental safety and
eliminates unsightly sag in 2’-by-2’ and 2’-by-4’ acoustic ceiling tiles.
WIRING INSTRUCTIONS
INSTALLATION INSTRUCTIONS FOR GOLD DIRECT FIR ED TANGENT SPEAKERS
For additional support, please see our speaker installation videos on the Lencore
website at: www.lencore.com
Please comply with all applicable building codes for installation. Lencore does not take
responsibility for installation of speakers, wiring or equipment.
13