LENCO IR-2002, Instruction Manual

Page: 9 / 57

UK-8
Display information
While the radio is playing, the frequency will be displayed, and if RDS information is available, station
name and any further RDS information such as programme name, track title and contact details can be
displayed. Stereo broadcasts are indicated with an icon at the top of the screen. To view further
information about the broadcast, press the
INFO button.
Other Settings
- Scan settings
FM scan is defaulted to stop at any available station, this would result the poor reception from weak
stations. To change the scan settings to stop only at stations with good signal strength, press the MENU
button then enter into the “Scan setting” section and select YES by the use of the SELECT control.
- Audio settings
The radio will automatically switch between FM stereo and mono reception, but you can override this and
switch this function manually which is helpful for poor signal reception.
To select listening in mono, press the MENU button then enter into the “Audio setting” section and select
YES by the use of the SELECT control.
Note: During FM stereo reception, the received L/R stereo sound will be automatically combined to one
single channel to suit the single speaker design of this radio.
AUX IN
AUX in mode plays audio from an external audio source such as MP3 player. To play audio with Aux in mode:
1.
Decrease the volume level on both the radio and the audio
source device.
2.
Connect the external audio source to the AUX IN (3.5mm)
stereo socket.
3.
Either press MODE until the display shows “AUX in” or select
“AUX in” in the main menu by the use of the SELECT control.
4.
Set the desired volume on the radio and the external audio
device if necessary.
Note: To further enhance energy saving, if the unit is left in AUX in mode and without any user operation
for three hours, the unit will switch itself to standby automatically;
To toggle select this function between on & off - In AUX in mode, press and hold the INFO button for longer
than two seconds, the display will show “ECO ON” or “ECO OFF”.
ALARMS AND SLEEP (remote control only)
Alarms
There are two wake-up alarms with snooze function and one sleep function to turn the radio off after a set
period. Each alarm can be set to start in a particular mode. To set
or change an alarm:
1.
Select either Alarm 1 or 2 in the main menu or press the
ALARM button on the remote control.
2.
Select the Alarm number (1 or 2) and set the following
parameters:
Enable: Off, Daily, Once, Weekends, Weekdays
Time:
Mode: Buzzer, Internet radio, FM
Preset: Last listened or 1-10
Volume: 0-32
3.
To activate the new settings, scroll down the menu using the
SELECT control and select “Save”. The display will show the
active alarms with an icon at the bottom left.
4.
The alarm will be triggered at the preset time. To temporarily
silence it, press the SNOOZE button on the remote control.
The radio will switch to standby for the set period, and the
silenced alarm icon flashes in the display.
5.
During alarm, you can change the snooze period by repeatedly
pressing on the SNOOZE button on the remote control.
Sleep
To activate the sleep function, either select it in the main menu by the use of the SELECT control or
repeatedly pressing on the SLEEP button on the remote control. The display will show the sleep time and
you can choose from: Sleep Off, 15, 30, 45, 60, 75, 90 minutes.
Once the sleep time has been set, it will return to the main menu.