LENCO CR-430DAB+, User Manual, Page: 9 / 55

9
7.11 To activate the snooze function, press the Snooze/Sleep button when the alarm sounds.
The snooze indicator (Zz) will be shown in the display: the alarm will silence and then sound
again after approximately nine minutes.
7.12 To turn off the alarm permanently, press the Alarm 1 button to display the alarm status.
Use the Forward ( ) button or Backward ( ) button until ‘Alarm status off’ is displayed,
then press the Enter button to accept and exit the mode. The alarm has been deactivated
and the alarm indicator will no longer be shown in the display.
Notes:
If the power is interrupted (or the unit is switched off using the rear switch) and batteries are
not fitted in the battery compartment, the alarm setting will be lost.
To set the second alarm, use the Alarm 2 button and then follow the steps above to set this
alarm.
If the DAB or FM radio wake up option is selected the alarm will play the last station listened to
in DAB or FM.
The clock display size/brightness is fixed and cannot be adjusted.
8. SETTING AND USING THE SLEEP FUNCTION
This function will switch off the radio automatically after a preset time interval.
8.1 With the radio of choice playing, press the Snooze/Sleep button and the sleep status is
shown in the display.
8.2 Press the Forward ( ) button or Backward ( ) button repeatedly until the desired sleep
interval (see sequence below) is shown in the display.
8.3 Press the Enter button to accept. The sleep timer is now activated and the display will show
the sleep indicator(s) and the time interval remaining before the radio switches off.
8.4 The sleep function will count down and the unit will switch off automatically after the time
interval selected has been lapsed.
8.5 To cancel the sleep timer, press the Snooze/Sleep button and then press the Forward ( )
button or Backward ( ) button repeatedly until ‘OFF’ is shown in the display. Press the
Enter button to accept.
9. USING HEADPHONES (not included)
A stereo headphone jack has been provided so that the unit can be used without disturbing
others. Plug in the headphones at the point marked ‘ ’ at the rear of the radio and adjust the
listening volume to your chosen level. Excessive sound pressure from earphones and
headphones can cause hearing loss. The speaker will not operate when earphones are fitted.
10. RESET
Moving the radio to another location in the country the pre ‐ tuned and stored stations may no
longer be available and it will be necessary to reset the radio back to the factory settings.
10.1 With the unit switched on, press and hold the Menu/Info button until the display shows
<Set Time/Date>, then press button to select the ‘system reset’.
10.2 Press the Enter button to confirm reset and ‘press enter key to reset’ will be displayed.
10.3 Press the Enter button once again to confirm. The radio will display ‘system reset’ and the
reset will begin.
10.4 A ‘full scan’ will then start and the display will show progressing slide bar.
10.5 When the scan is finished the radio will play the first alphanumerically found station. All
stored programmed stations will be lost during reset.
Note: If press button again in step 10.1 the ‘software number’ will be displayed.
OFF