Clutch
Tabs
FIGURE 4.4
Install the Campagnolo® adapter onto the shaft and reinstall the 16mm hub nut. Tighten the nut to
2.5 N m (22 in-lb). (Figure 4.1)
Load the Campagnolo® cassette onto the adapter.
7.
8.
Note:
-
tor in one orientation. However, it is possible to install them out of order. Before installing the lockring
make sure that the sprockets are in the correct order and the spacers are installed properly. Refer to the
manufacturers documentation if necessary.
Thread the lockring onto the cassette and tighten to the specified torque.
5.
Note:
Make sure that the cassette spins freely counter-clockwise. If the cassette does not spin freely remove
the lockring, loosen the hub nut, check that the adaptor spacer is installed, and repeat steps 7-9 above
ensuring proper torque on all fasteners.
Note:
In some cases the bearing inside the adaptor will come loose during installation. If the bearing moves,
be sure that the spacer between the bearings is still in place and push the bearing back into place by
pressing around the outside edge of the bearing.
Note:
It may be necessary to turn the adaptor counterclockwise or press the clutch tabs down with your
(Figure 4.4)
CASSETTE ADAPTER INSTALLATION
Cassette
Adaptor
Cassette
Hub Nut
Cassette
Lockring
FIGURE 4.1
16
