7
WARNING! Do not expose the table to an excessively humid environment. If the
table gets wet, remove the plug from the outlet and have it checked by an Authori
-
zed Service Centre.
WARNING! The table was not designed to work in environments with explosice at
-
mospheres , in the presence of fine dust or corrosive gases, in the presence of acids,
corrisive agents, salt; it is also not suitable for operation in the presence of ionizing
and non-ionzing radiation (X-rays, laser, microwaves, ultraviolet rays).
STORAGE! For the correct functioning of the electrical equipment the storage of the
table must be at a temperature between -25° C and +55° C, and only for short periods
not exceeding 24 hours, to +70°C.
The table has no special requirements for storage, provided that it takes place in
a closed and dry rooms; this condition should also be ensured during all phases of
transport.
The table has been designed and built to operate in a closed and dry room. The ambient operating condition are:
If the environmental conditions are particularly critical it is advisable to provide the room with an adequate air condi-
tioning system to bring the humidity and temperature values within acceptable limits.
Temperature: 5° ÷ 40° C
Humidity: 30% ÷ 95% without condensation.
3. ENVIRONMENTAL WORKING
CONDITIONS AND STORAGE
4. PRELIMINARY CHECK
Before the setting at work of the table, make sure that:
There is no damage to the equipment due to the phases of transport and handling; eventually proceed
to solve these problems by contacting Brusaferri & C.;
All packaging components have been removed;
Check that the supply voltage is equal to the rated one as defined in § 2.5. Power Supply;
Check the efficiency of the operation of the control equipment.
Before using the table for the first time, make sure qualified personnel carry out some tests in safety condi-
tions.
