15
* All the four outputs of the MLF-100 operate in adjacent RF output channels. This means
that the user setups only the first modulator and all the other three modulators have the
same settings and automatically are being programmed in adjacent channels.
E.g. If the user sets the CH21 in UHF band on modulator No1 the other three modulators
will be automatically set to CH22, CH23 and CH24, respectively.
The status section in (Figure No 10) provides a general idea to the user of the current
payload (according to the selected programs) comparing to the max. output payload.
It is recommended that the user must not exceed the 85% from each output, since all
the bitrate are variable according to their specific content.
4.2.7 - “TS settings” page
In this section (Figure 11), the user is able to setup all the TS settings of the four multi-
plex in MLF-100’s output.
Figure No 10
Figure No 11
