TPG10 User Manual
Version GS 1607
1
Version GS 1607
Introduction
TPG10 had revolutionised its display format and is the first in the world with fully graphics display on
its operation. With its simplicity of the graphics display, step by step instructions were clearly
understood universally without any language barrier.
Comes with an internal printer, the graphic display results can be printed individually after each test.
It can store up to 70 Test Results. The Test Results can be recalled and viewed from its memory
after completion of each test or can be printed out when required. If needed, these results can be
transfer and stored in the computer via an USB cable link. This can be done only with the Battery
Analyser Software installed in the computer beforehand.
The Battery Analyseronly operateson all 12V Batteries and is able to perform four tests namely:
1.
Battery
Test:
Analyses the battery condition using microprocessor controlled testing methods without
the need of fully charging it before test.
Consume very little current during testing, hence the test can be repeated numerous
times without any worry on battery drainageand results are highly accurate.
Extremely safe as there is no sparks created during clamping and full analysed result
takes less than 8 seconds to obtain.
Temperature compensation on end results.
Powered up by testing battery or any external DC source ranging from 9V to 15V. The
analyser is meantto be operated on 12V flooded lead acid, sealed lead acid, and VRLA,
EFB (Start/Stop) and AGM batteries. No maintenance is required during its lifetime
service.