LELY SPLENDIMO TC, Operator'S Manual

Page: 18 / 26

7.3
Intermittent maintenance
Intermittent maintenance has to be carried out:
• At the start of the haymaking season;
• Before prolonged storage of the machine;
• When the machine is used extensively during the season.
- Grease the PTO shafts.
- Grease the profiled tubes of the PTO shaft.
- Grease the spring-loaded locking pins of the yoke lock of
the PTO shaft.
- Check if the PTO shaft telescopes smoothly. A damaged
PTO shaft may cause excessive wear and tear to the
machine and tractor.
- Grease the PTO shaft above the drive element in way of the
grease nipples on the cross assemblies. For this purpose,
the cover (A, fig. 18) has to be removed.
Remove soil and/or crop material, if any, from the hat.
- Grease the pivots of the intermediate frame (fig. 19).
- Grease the bearing blocks of the conditioner rotor (fig. 20).
- Grease or lubricate all remaining pivot points.
- Apply a few drops of oil to the cams of the breakback
device (fig. 21).
- Check correct prestress of 160 mm of the spring of the
breakback device (fig. 21).
- Check the machine for damage and flaws.
- Check the condition of wear plates, mower discs and knives
(for knife replacement - see par. 7.4).
- Check the knife bolts for tightness (fig. 22).
Torque 50-60 Nm (5-6 kgm).
- Check the mower discs for tightness (fig. 22).
Torque: 150-250 Nm (15-25 kgm). The split pin locking the
castellated nut is not allowed to protrude above the
pressure piece.
We recommend that you first tighten the nut to the minimal
torque and then keep turning until the split pin can be
fitted.
40
20
8 h
21
40 h
160 mm
22
150-250 Nm
(15-25 kgm)
50-60 Nm
(5-6 kgm)