innovators in agriculture
EN-15
7 MAINTENANCE
• Correct machine servicing is vital for ensuring reliable
and safe operation.
• Install supports underneath the cutter bar if it is lifted
from the ground and you intend to carry out work
underneath it.
The cutter bar of the SPLENDIMO 320 FC mower can be accessed
more easily for maintenance work by opening the front safety
guard. Proceed as follows:
- Lower the mower conditioner onto the ground.
- Remove the two safety guards from the sides.
- Remove the locking pin on the left-hand side of the safety guard.
- Turn the guard forwards and lower it onto the ground.
7.1
Maintenance after operation
- Clean the machine thoroughly. After jet-cleaning, allow the discs
to rotate briefly so that any water under the discs is flung away.
- Check the mower knives and discs for tightness and damage
(torques: see § 7.3).
- Check the protective covers for any damage.
- Grease the machine with an anti-corrosion agent.
- Grease the piston rod with an anti-corrosion agent if the machine
will not be used for a long period.
Remove the agent before using the machine again. If not, the ram
seal may be affected if the anti-corrosion agent hardens.
7.2
Lubrication
All lubrication points of the machine can be greased with a
biodegradable grease (Total Biomultis SEP2), unless stated
otherwise.
- The PTO shafts must be greased every 8 working hours via the
grease nipples on the cross assemblies, protection tubes and
overrun safety (fig. 17).
- Grease the profiled tubes of the PTO shaft every 8 working hours
(fig. 17).
- Grease the bearing blocks (fig. 18) of the conditioner rotor every
8 working hours.
- Grease the PTO shaft above the drive element every 500 working
hours (or yearly) via the grease nipples on the cross assemblies. To
do so, remove the three bolts from the cover A (fig. 19) and the
sealing plate B.
Remove any soil or crop from the hat.
- Grease or lubricate all other pivot points every 40 working hours.
8 h
8 h
17
18
8 h
19
500 h
A
B
Summary of Contents for SPLENDIMO 280 FC
Page 2: ...innovators in agriculture...
Page 4: ...EN 2 innovators in agriculture...
