LELY SPLENDIMO 240 MC, Operator'S Manual, Page: 16 / 30

EN-14
If the machine hits an obstacle during mowing, it can move
backwards thanks to the extension of the breakback device (fig. 13).
- After extension of the breakback device, reverse a few meters
until the breakback device has locked back into position.
The machine is protected against overload by either a slip clutch or
a shear bolt clutch.
- Replace a broken shear bolt of the shear blot clutch with an
M8x40 - 8.8 Din 933 bolt.
- If the machine needs to be placed in the transport position at the
end of its operation, wait until all moving parts have come to a
standstill.
When folding up a machine with rotating parts, the PTO shaft
can be seriously damaged.
Please also refer to chapter 3 “Transport”.
6 DISMOUNTING FROM THE TRACTOR
Always place the machine on hard, even ground.
- Lower the mower.
- Lower the tractor hydraulics until the abutment pins of the ram are
positioned in the hooks of the locking device (fig.14).
Pull the control cord of the locking hook to position the hooks in
line with the abutment pins.
- Place the parking jack in the bottom position.
- Lower the tractor hydraulics further until the parking jack rests on
the ground.
- Switch off the tractor engine. Disengage the PTO shaft from the
tractor PTO.
- Place the PTO shaft in the parking chain (fig. 15).
- Depressurize the hydraulic system and disconnect the hydraulic
hose.
- Place the dust cap on the plug and hang the plug on the headstock
support.
- Remove the control cord for the locking hook from the tractor
cab.
- Disengage the top link from the machine.
- Disconnect the lower arms from the machine.
13
!
14
15