LELY CENTERLINER S, Operator'S Manual

Page: 18 / 34

4.2.2
PTO speed
If so required, a PTO speed of 750 or 1.000 rather than 540
r.p.m. can be used. In that case another gear set than the one
listed in the output rate chart should be fitted.
Select the set that comes closest to the spinner disc speed
listed in the chart.
The chart below shows the spinner disc speeds for all
possible gear sets.
Use the lowest speed possible for obtaining the required
working width. A higher speed increases wear and tear of the
drive and the spoons. Soft crop may be damaged as well.
Do not use a gear set which is not listed in the chart. Do not
allow the spinner disc speed to exceed 1059 r.p.m. as a result
of an increased PTO speed.
If so required, a PTO speed of 750 or 1000 r.p.m. can be used
as a means for saving fuel. This can be achieved by reducing
the motor speed until the PTO shaft turns 540 r.p.m.
Example:
A PTO shaft turns 1000 r.p.m. at a motor speed of 2100 r.p.m.
For the PTO shaft to turn 540 r.p.m. in the same gear position,
the motor speed should be: 540 2100
1000
´
= 1134 r.p.m.
48
CHANGE GEAR
top 12 13 14 15 16 17 18 19 20 21 22 23
below 23 22 21 20 19 18 17 16 15 14 13 12
CENTERLINER S/SL
®
Spinner disc r.p.m.
PTO speed 540 r.p.m. 282 319 360 405 455 510 572 641 720 810 914 1035
PTO speed 750 r.p.m. 391 443 500 563 632 708 794 891 1000 - - -
PTO speed 1000 r.p.m. 522 591 667 750 842 944 1059 - - - - -