When using the burning pen, do not burn with the pen vertically oriented (straight up and down).
Instead, hold it at a 45-degree angle, or at a position that allows the heat to rise away from your
fingers.
Safety:
• Always make sure an unattended set is turned off. It only takes seconds to heat up again.
• If any wire appears frayed or burned, send the set into the factory to have a new wire installed.
• Do not make your own pen tips. Our pen tips are made from a space-age alloy that is not available
in stores; if you use an alternate material, like NiChrome, you could damage the setʼs components.
Such damage will not be covered under the factory warranty.
Tip: When using the set for the first time, it is always wise to test it on a sample piece
of material (This should be the same as the material you will be working on). With this
sample, you will be able to try the pen and observe the results before applying it to the
main art piece. This will allow you see what pen will do the best job, what heat setting is
best, and it will allow you to see how fast you should apply the pen. If you are satisfied
with the test, apply it to the main art piece. If you are not satisfied, change the heat
setting, perhaps the pen tip, and try the sample again.
2.
The Detail Master Burning Pen
(fixed-tip shown)
