Blower
• Use an air filter, if air is dusty.
• Air flow can be adjusted by the LEISTER air flow adjuster.
Compressed air
• When using compressed air, an oil and water filter must be connected.
• Air flow can be adjusted by air flow adjuster.
Operating conditions LEISTER Welding-Pen A
Fit appropriate nozzle as required.
Connect air supply with corresponding
hose connection (7).
Adjust air flow by means of air flow adjuster or pressure reducing valve.
ATTENTION: Keep minimum required air flow according to data on page 2
Connect tool to the mains.
Set hot-air temperature by adjusting of air flow.
(Temperature must not exceed 600°C)
Heat up tool for about 5 minutes.
Let the tool cool down after use!
Operating conditions LEISTER Welding-Pen S
Fit appropriate nozzle as required.
Connect air supply with corresponding
hose connection (7).
Adjust air flow by means of air flow adjuster or pressure reducing valve.
ATTENTION: Keep minimum required air flow according to data on page 2
Connect tool to the mains.
Adjust hot-air temperature by use of the potentiometer.
Heat up too for about 5 minutes.
Let the tool cool down after use!
Change of nozzle
• Let the tool cool down before changing the nozzle.
• Do not touch hot nozzle and only lay it on heat resistant surface because of fire
hazard.
• Nozzles can easily be screwed (M14) onto the heat protection tube.
• Use only LEISTER nozzles.
OPERATION
AIR SUPPLY
4
USAGE
Welding-Pen
S
S
S
S
S
S
S
A
A
A
A
A
A
A
