Leister Uniplan Wedge, Operating Instructions Manual, Page: 5 / 12

Drive
ON/OFF
SET - value adjustment
– +
M
WELDING– PARAMETERS LEISTER Uniplan Wedge
Welding speed
Adjust welding speed using keys , , , depending on the material to be
welded and the ambient temperature.
The SET value is shown on
display (13).
+ –
Hot wedge welding position
• Depending on the material thickness, pre-adjust the position of the hot wedge
(6) in relation to the drive/pressure roller (8) in accordance with Fig 2, Page 4.
• Procedure
– Loosen
fixing screw (20)
– Using adjusting screw (21) , adjust the position of the hot wedge in relation to
the drive/pressure roller. (One complete turn = 1.25 mm)
– Push holding arm (15) up to the stop in the direction of the hot wedge.
– Tighten fixing screw (20).
-Tracking correction of the drive/pressure roller
• Tracking control should be carried out using the track
adjustment screw (22), see functional directions on the
lifting device (12).
• Carry out test run.
21 20
15
5
12
22