4
BA Hotwind S / 06.2001
Operation
• Connect tool to the mains.
• As required, push-fit appropriate nozzle or reflector.
• Set
on/off switch (2)
to stage 1.
• Reduce air flow as required by using the
air slide (5).
• Adjust hot-air temperature by using the
potentiometer (4).
• Set
heater switch (3)
to stage 3 and allow to warm up for about 5 min. Make
sure that the hot-air can flow freely, as back pressure can develop and possibly
damage the tool (
fire hazard
).
• LEISTER Process Technologies as well as the Service Centres offer free training
courses for all applications (see page 1).
• After use, turn
heater switch (3)
to stage 2, and
on/off switch (2)
to stage 1 and
let the tool cool down (preventing warm air back pressure).
CAUTION :
,
When fixing the tool into an installation, the mains connection must have a
suitable
device for disconnect all poles from the mains
with a
3 mm distance
between contacts.
,
The temperature control of the tool corresponds to the risk grade 1 according
to EN 954. For higher power demand additional safety precautions have to be
taken according to the risk grade.
• Temperature adjustment with external potentiometer.
• Temperature control signal with external control voltage (VDC).
• Temperature control with additional LEISTER cascade controller (KSR) should only
be fitted and adjusted by the LEISTER Process Technologies.
• Only LEISTER nozzles and reflectors must be used.
•
The tool's
air intake (6)
should be cleaned with a brush if nescessary.
•
Check
power supply cord (1)
and plug for any possible electrical or mechanical
damages.
• Repairs have to be carried out by authorised
LEISTER Service Centres
only. They
guarantee a specialized and reliable
repair service within 24 hours
using original
LEISTER spare parts.
• Guarantee and liability are in accordance with the guarantee certificate as well
as with the currently valid general business and sales conditions.
• LEISTER Process Technologies rejects any guarantee claims for tools which are not
in their original condition. The tools must never be altered or changed.
Technical data and specifications are subject to change without prior notice.
Your authorised Service Centre is:
GUARANTEE AND LIABILITY
SERVICE AND REPAIR
MAINTENANCE
ACCESSORIES
SPECIAL FEATURES
LEISTER Process Technologies, Riedstrasse, CH-6060 Sarnen / Switzerland
Tel. + 41 41 662 74 74 Fax + 41 41 662 74 16
www.leister.com [email protected]
®
