27
Countdown counter for heating process
Cooling process
Setpoint setting locked
Line voltage is present, FUSION 1 is switched off
Startup
As soon as the FUSION 1 is connected to the
line voltage specified on the
type plate (5)
, the
current software version appears on the
LCD
display (11)
for approximately 2 seconds.
If the
hot-air blower switch (12)
is at position
“0”, the power plug symbol appears on the status
display area of the LCD display.
Setting the
temperature set-
point
Set the switch for the
hot-air blower (12)
to
position “1”. The
potentiometer (10)
can now
be used to set the air temperature. The current
setting is displayed on the
LCD display (11)
.
Heating process
Once the
potentiometer (10)
is no longer being
pressed, the system switches to the actual value
display. During the heating process, the current
temperature flashes on the display. An arrow
pointing upward indicates that the temperature
is rising.
6. LCD display
The LCD display (11) is subdivided into three display areas:
6.1 Status display symbols
6.2 Working display
Status display
Setpoint/actual welding temperature value
Drive motor bar display
Summary of Contents for FUSION 1
Page 83: ......
