22
B975 User Guide
Chapter 4
Mounting & Assembly
4-20
With the socket board stop
fully retracted, and the 3/4" side of
the jig facing you, lower the jig onto
the board. Slide the jig over until the
left edge of the board touches the
socket board stop as shown.
Clamp the jig in place.
4-21
Place the router on the jig and
adjust the tip of the bit up or down
until it’s at the center of the line.
Rotate the bit and collet to ensure
it spins freely and does not contact
the eBush.
4-19 Depth of Cut
Select a board at least 9-3/4"
[248mm] wide and 1/2" to 3/4"
thick. Length is not important as
long as it can be clamped safely in
the vice.
Set the depth of cut by marking a line
3/4" from the top end of the board.
Clamp the board in the vice with the
depth of cut line facing you.
