47
Figure 4:
Emptying the tank
GB
WARNING:
NEVER OPERATE THE DEVICE IN A PARTIALLY ASSEM
-
BLED CONDITION!
6. SPECIAL ACCESSORIES
The window cleaner can be attached to all Leifheit telescope handles thanks to the Click System function. This allows you to also reach
hard-to-reach / high surfaces:
Steel telescope handle (65 - 110 cm)
Steel telescope handle with an articulated joint (65 - 190 cm)
Aluminium telescope handle (145 - 400 cm)
7. DISPOSAL / BATTERY REMOVAL
The battery must be removed before disposing of the device. To do so, unplug the device and open the battery compartment
by removing the screw. Disconnect the cable connection and dispose of the battery properly.
The symbol on the product or its packaging indicates that this product is not to be treated as normal household waste, but
rather must be taken to a collection point for recycling electrical and electronic equipment. The battery is to be removed before disposing
of the device and taken separately to corresponding collection points. You can obtain additional information from your local authorities,
the municipal waste disposal service or the shop where you purchased the product.
Attention: always observe the following information when handling lithium-ion rechargeable batteries:
• Do not damage the rechargeable battery or open it as this can cause a short circuit. Risk of fire! Risk of hazardous or poisonous
substances.
• Do not place the rechargeable batteries in open flames; do not subject them to direct sunlight or heat.
8. COMPLIANCE / DECLARATION OF CONFORMITY
Leifheit herewith declares that this device is in compliance with the basic requirements and the other pertinent regulations of the Directi-
ve 2004/108/EC, 2006/95/EC, 2011/65/EU (RoHS) and Directive 1907/2006/EU (REACh).
You can view the EU declaration of conformity at www.Leifheit.de
9. TROUBLESHOOTING
Error
Note
LED flashes red
1. The rechargeable battery is empty. Recharge the device.
2. I f the device was not used for 2 minutes while it was switched on, sleep mode is activated and the LED
will flash red. Upon contact between the rubber lip and e.g. a window pane, full power is automatically
reactivated; shut the device off to finish operation.
3. If the device is partially or fully charged
► Use the main power switch to shut the device off and immediately on again - up to three times - to
exclude a short-term error.
If the flashing continues
► Let the device stand at room temperature for a few minutes while it is switched off. Low temperatures of
the device can cause short-term errors.
If the flashing continues
►Contact your seller where you purchased the device.
Streaks on window
- Results can be optimized by slight pressure on the window vacuum toward the direction of the window
pane.
- Inspect the rubber lip for damage. The rubber lip can be replaced if required, please contact the manufac-
turer for more information.
Water exits from the
ventilation opening
1. The tank has reached the maximum limit of 100 ml and must be emptied.
2. Fitful movements while using the device overhead can cause water to leak through the fan. Empty the
tank regularly and avoid very fitful movements of the device.
IM_Fenstersauger_51113_06-08-2014.indd 47
07.08.2014 09:44:05
