Pairing
Before the pairing begins, make sure your NAS flashgun(s) are
set to Auto Channel mode
(2)
.
Turn off both
flashgun(s) and the Air 10s.
1
OFF
Hold
Mode button
for 1 second for open mode. Users need to turn off if
they are using NAS flashgun(s) that do not support the Open mode.
1
OPEN Mode
to
Press the
group selection button
A
B
/
C
/
D
/
A BCD
select a different group and press the same button again to end.
Turn off the group by pressing
when the group is blinking. Only
MG10 supports the mix of TTL and M in advance group.
2
Press and hold
Advance Group
A B C D
1 sec. to change to the advance group
Basic Group
A B C D
&
A BCD
/
Press to
enable or disable the modeling light
on flash.
3
Rotate the dial to adjust
the Power of M mode / Flash exposure
compensation of TTL mode when the group is blinking.
Adjust power & TTL
Press and hold
to
change zoom position
when the group is blinking
or
rotate the dial to adjust manually.
4
Flash exposure
For the basic group
A B
s :
C D
All groups work in the same mode.
To change different mode by
pressing M/TTL mode button.
For the advanced groups of
:
TTL and M mode can work in 4 advanced groups. To change mode between
M and TTL of a selected group, press “M/TTL” button when the group blinks.
A B
C D
Hold the
dedicated buttons
(2)
on your NAS flashgun(s) for 3 seconds
until you hear the beeping sound.
2
HOLD
3 Sec.
Hold both
Panel Lock button
and
Power on/off button
for 3 seconds
until the Pilot light is blinking in orange colour.
3
Blink!
4
Memorized!
NAS flashgun(s) and Air 10s
stop beeping and blinking
after the
pairing is done. Pairing setting
remains unchanged
even when both
devices are powered off. Do not operate until the process finished.
Control
