Leibinger JET3 Service Manual Download Page 5

Page: 5 / 6

Service Manual JET3

S E R V I C E - D O C U M E N T A T I O N

Sequence of adjustment:

Open the 5 retaining screws of the mounting plate untill it could be moved lightly by hand.

Relocate the mounting plate until the ink stream reaches the final adjustment position.

Tighten the retaining screws and check the jet position again.

retaining screws (fix with Allen key (SW 1,5) or Torx (T6)).

6. Open the nozzle seal completely with the arrow button unless the ink stream goes inside the

charging tunnel and the nozzle seal reaches the final position.

The ink stream should be concentric inside the charging tunnel and parallel to the deflection
plates. If not, readjust the position again.

Switch on the „Ink

-Flow-

Sensor“.

Summary of Contents for JET3

Page 1: ...Service Manual JET3 S E R V I C E D O C U M E N T A T I O N 61 Next step print head adjustment ...

Page 2: ...d cover and press the button Jet Adjust The nozzle seal opens automatically to the jet adjustment position 4200 4 Align the ink stream with the two adjusting screws according to the sketch into the gutter tube Required tools 6 fold magnifying glas Allen key SW 1 5 Attention It is not allowed to use a golf ball head allen key The screw heads could be damaged adjusting screws ...

Page 6: ...Service Manual JET3 S E R V I C E D O C U M E N T A T I O N 66 8 Close and open again the nozzle seal Do a final check up for the correct position of the ink stream ...