Mounting and start-up
2 Mounting and start-up
2.1 Mounting the frame
Warning!
Risk of injury due to weight of component
This can cause injuries.
The spreader is significantly heavier when the hopper is full.
Attention must therefore be paid to the proper mounting of the spreader on the carrier vehicle,
and to the carrying capacity of the vehicle tailgate or other panels. If necessary, fit with
assistance.
Warning!
Danger of excessive loads!
This can cause injuries.
The load carrying capacity shall be based on the regulations for load bearing equipment.
Warning!
Risk of injury.
Do not operate the spreader if there are technical safety defects.
The
POLARO
®
can be mounted on the front or rear of the tractor, off-road vehicle or ATV.
The
POLARO
®
can be mounted using an auxiliary bracket. Mounting holes are provided on the back of the
framework. for this purpose.
Remove the hopper before mounting the spreader.
The recommended discharge height is 0.40 - 1.00 m.
For information on disassembly, see
Notice
Dispose of packaging materials properly or save them for return to the manufacturer.
Retain the special pallet, as it is ideal for transporting the spreader.
2.2 Mounting the hopper
8 / 34
1.1
POLARO
®
Summary of Contents for POLARO
